Paul Mueller Company Academy

 2 minute read or watch

Getting a manway out of round can seriously hinder your production schedule and in some cases can even cause unrepairable damage to your manway. Today, Jeremy is going to show you how to install a manway in a small tank head while keeping it round in the process.

2 minute read or watch

With multiple dimple sheets that need to be tacked and fit to the same tank head it can be difficult to get them to line up properly. Today, Jeremy is going to show you how to fit and trim dimple coil to a tank head.

There are a couple challenges you might face when trimming and fitting dimple sheets to a tank head.

• Challenge 1: The dimple doesn't lay down flat against the tank head.
• Challenge 2: It can be difficult to trim the dimple sheets to fit together correctly.

Here's how to overcome these two challenges:

Manufacturing makes the world go round and that's why safety is typically the number one priority for manufacturing facilities like yours. Ladders are a big part of keeping production safe and on track. Ladders are used to check and maintain equipment, which helps keep the quality of your products secure. Yet, 20 percent of fatal and work loss injuries can be attributed to falls from ladders. The Occupational Health and Safety Administration (OSHA) recently put a focus on ladders in the workplace and enacted some new regulations. As a company are you prepared to stay up-to-date on those regulations?